HCDZ Replacement Remote Control for H9118 Lennox ERT3033/ERT3036, Capella 33, Capella 36, Spark 33, Spark 36,MPE-33-2, Radiant Electric Fireplace

Your electric fireplace remote control won¡¯t work due to a low battery power supply or damaged battery, a faulty signal receiver, a nonworking power button, a control transmitter that isn¡¯t programmed well, and a signal receiver problem with the fireplace. Now fix the issue by following our below methods:Solution: 1.First, remove all the batteries and replace them with new ones. 2.Insert the batteries in the right place properly. 3.Ensure that the batteries have enough power supply to operate the fireplace. 4. If the manual switch of the fireplace is turned in the ¡°ON¡± position, it may override the remote control signal. So, first, turn off the manual switch and then press the ON button of the remote. 5.Make sure you operate your remote control about 25 feet from the fireplace. Otherwise, the appliance will fail to get the signal. 6.Sometimes there may have a loose wiring problem in the remote. Unscrew it and tighten all the work correctly. 7. If the problem is the fireplace receiver signal, call the manufacturer.

• Please note: This remote control is not a universal model for Heat Surge Fireplaces. If you are uncertain about the correct remote for your specific unit, we recommend contacting us first¡ªbefore you place an order.
• IR Replacement remote control
• No battery and instructions included
• No programming needed
• Easy to Use, Just put in fresh batteries , then it will work .